5
Dust, chips and noise can be health
hazards. Be sure to wear personal
protection gear such as safety goggles
and dust mask. Use a suitable dust
collection system.
The use of incorrect mains supply or a
damaged power cord can lead to
injuries caused by electricity.
4. Machine specifications
4.1 Technical data
Drilling capacity(Iron/Steel)
32/32mm
Spindle to column
215mm
Spindle travel
85mm
Spindle taper
MT-3/B16
Chuck size
16mm
Column diameter
80mm
Table size
290 x 290 mm
Overall height
1050 mm
Number of speeds
16
Range of speeds
180 - 3000 rpm
Net weight
61 kg
JD-3285-M:
Mains
230V ~1/N/PE 50Hz
Output power
0.75 kW (1 HP) S1
Reference current
4.6 A
Extension cord (H07RN-F): 3x1.5mm²
Installation fuse protection
10A
JD-3285-T:
Mains
400V ~3L/N/PE 50Hz
Output power
0.75 kW (1 HP) S1
Reference current
2.4 A
Extension cord (H07RN-F): 5x1.5mm²
Installation fuse protection
10A
4.2 Noise emission
Acoustic pressure level
(according to EN ISO 11202):
Idling
LpA 71,8 dB(A)
In operation
LpA 84,0 dB(A)
The specified values are emission
levels and are not necessarily to be
seen as safe operating levels.
As workplace conditions vary, this
information is intended to allow the
user to make a better estimation of the
hazards and risks involved only.
4.3 Content of delivery
Head assembly
Table
Column and bracket assembly
Machine base
16mm keyless chuck
MT-3 arbor
3 downfeed handles
Table bracket lock handle
Table bracket rising handle
Drill chuck guard
Drift key
Operating tools
Assembly kit
Operating manual
Spare parts list.
5. Transport and start up
5.1 Transport and installation
The machine is designed to operate in
closed rooms and must be placed
stable on firm and levelled ground. The
machine can be bolted down if
required.
For packing reasons the machine is
not completely assembled.
5.2 Assembly
If you notice transport damage while
unpacking, notify your supplier
immediately. Do not operate the
machine!
Dispose of the packing in an
environmentally friendly manner.
Clean all rust protected surfaces with a
mild solvent.
Attach the column assembly (A, Fig. 1)
to the base (B, Fig. 1) with four M10
hex cap bolts (C, Fig 1). Tighten firmly.
Fig 1
Thread the table bracket lock handle
(A, Fig 2) into the table bracket (B, Fig
2).
Fig 2
Slide the table bracket rising handle
(B, Fig 3) onto the table bracket shaft.
Fig 3
Turn the handle until the set screw is
opposite the flat section on the shaft
and tighten the set screw (A, Fig 3).
Insert the table into the table bracket.
Tighten the table lock handle.
With the aid of a second person,
carefully lift the head onto the column
top.
Caution: The head assembly is
heavy! Use care when lifting onto
the column!
Rotate the head assembly until the
sides of the belt cover are parallel with
the sides of the base.
Tighten two set screws (A, Fig. 4).
Fig 4
