3
Cross slide travel
300mm
Top slide travel
130mm
Tool size max
25 x 25 mm
Longitudinal feeds
0.04–2.5mm/r
Metric threads...24
0.5–20mm
Inch threads…61
1-5/8 – 72 TPI
Lead screw pitch
6mm
Coolant tank capacity
15 L
Overall L x W x H
2830/ 3320 x 1100 x 1470mm
Net weight 2900/ 3145 kg
Mains
400V ~3L/PE 50Hz
Output power
7.5 kW (10.2 PS) S1
Reference current
10 A
Extension cord (H07RN-F):
4x2.5²
Installation fuse protection
25A
4.2 Noise emission
Acoustic pressure level (EN 11202):
Idling at maximum speed 81,2 dB (A)
The specified values are emission
levels and are not necessarily to be
seen as safe operating levels.
As workplace conditions vary, this
information is intended to allow the
user to make a better estimation of
the hazards and risks involved only.
4.3 Content of delivery
Cast iron stand
6 Leveling pads
Pull out chip tray
Splash guard
250mm 3-jaw universal chuck
300mm 4-jaw independent chuck
300mm faceplate
Four way tool post
Steady rest
Follow rest
Foot brake
Coolant system
Halogen work light
MT-4 (MT-5) life centre
MT-5 fixed centre
MT5/MT7 centre sleeve
Threading dial
Operating tools in tool box
Oil can
Operating manual
Spare parts list.
(see end of document for detailed
content)
4.4 Machine description
Fig 1
A….Lathe bed
B….Headstock
C….Carriage
D….Top slide
E….Cross slide
F….Four way tool post
G….Apron
Fig 2
A…..Tailstock
B…..Lead screw
C…..Feed rod
D….Gear box
E…..Follow rest
F…..Steady rest
5. Transport and start up
5.1 Transport and installation
The machine will be delivered in a
closed crate.
For transport use a forklift or hand
trolley. Make sure the machine does
not tip or fall off during transport.
The machine is designed to operate
in closed rooms and must have
sufficient floor space to operate it
and to have access from all sides.
Floor plan:
GH2260/2280ZX
5.2 Assembly
If you notice transport damage while
unpacking, notify your supplier
immediately. Do not operate the
machine!
Dispose of the packing in an
environmentally friendly manner.
Clean all rust protected surfaces with
petroleum, diesel oil or a mild
solvent.
Unbolt the lathe from the shipping
crate bottom.
Move the tailstock to the tailstock
end of the bed.
Place 2 steel rods of sufficient
strength into 2 holes of lathe bed.
Sling the lathe with properly rated
straps ( Fig 3)
Fig 3
Caution:
The machine is heavy!
GH 2260 ZX
2900 kg
GH 2280 ZX
3145 kg
Use great care.
Assure the sufficient load capacity
and proper condition of your
lifting devices.
Never step underneath suspended
loads.
Use a machinist’s precision level on
the bed ways and check to make
sure that the lathe bed is level.
The lathe bed must be level to be
accurate.