Promac 1000-004-068, Руководство по эксплуатации

Страница: 14 / 80

14
12.0 Troubleshooting
Symptom Possible Cause Correction *
Motor will not start.
Machine unplugged from wall. Check all plug connections.
Fuse blown, or circuit breaker tripped. Replace fuse, or reset circuit breaker.
Cord damaged. Replace cord.
Chuck guard not closed. Close chuck guard.
Motor brushes worn Replace brushes
Spindle does not come up to
speed.
Extension cord too light or too long. Replace with adequate size and length cord.
Low current. Contact a qualified electrician.
Machine vibrates excessively.
Base on uneven surface. Locate machine on even floor.
Machine not bolted to the floor Bolt machine to the floor
Unbalanced cutting tool Reduce speed
Workpiece deflection Improve workpiece clamping
Tool deflection Reduce tool length
Slide backlash Adjust slides
Slides running dry Lubricate with oil
Dull tool tip Re-sharpen or change tool
Chip load too high Reduce depth of cut or feed
Noisy operation
Spindle quill dry Lubricate with oil
Lead screw nuts have play Adjust X and Y axis nuts
Tool tip burns
Cutting speed too high Reduce spindle speed
Dull tool tip. Re-sharpen or change tool
Dry cutting. Lubricate with oil.
Feeding too slowly. Increase feed rate.
Drill leads off
Cutting lips or angle not equal Re-sharpen drill bit.
Drilled hole off centre Drill a pilot hole first
Bent drill bit. Use a proper drill bit
* WARNING: Some corrections may require a qualified electrician.
Table 1
13.0 Environmental Protection
Protect the environment.
Dispose all packaging material in an environmental friendly manner.
Dispose cutting chips and coolant in an environmentally friendly manner.
Your appliance contains valuable materials which can be recovered or recycled. Please leave it at a specialized institution.