18
Chapter 5
Scenting via HVAC System
Step 3: Installing the Top Anchors or Screws
Set the mounting bracket aside. Use an electric drill to make a 1/8” pilot hole at the exact location you
marked. This will serve as a guide for the anchors or sheet metal screws. If the appliance is being mounted
on drywall, use a hammer to gently tap the tip of the anchors into the wall. Then screw them straight into
the drywall.
Step 4: Marking the Bottom Anchor Holes
Now you can mark the bottom holes using the mounting bracket as a template. Hold the mounting bracket
in place and screw the flat-head screws half way into the top anchors. This will prevent the bracket from
moving. Now use the pen or pointed tool to mark the location for the two bottom holes. Unscrew the top
screws and set the bracket aside.
Step 5: Installing the Bottom Anchors or Screws
Drill a 1/8” pilot hole at the exact spot you marked. For drywall mounting, gently hammer the tip of the
anchors, then screw them in straight.
Step 6: Hanging the Mounting Bracket
Hang the mounting bracket by holding the bracket so the top holes match up with the anchors or wall
holes, then screw the 2 short, flat-head screws through the holes in the bracket. Tighten the screws firmly,
but do not crack the bracket.
Step 7: Power Supply
Plug the power adapter into the back of the machine.
HINT: If you use an electric drill with a Phillips driver head,
make sure the head fits the anchor perfectly, as the anchor
or screw can strip easily. Set the drill to a slow rotation.
5
