Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is
fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time, let the water
run to make sure that the water is clear and free of impurities. If this precaution is not taken,
there is a risk that the water inlet can get blocked and damage the appliance.
The water supply to the appliance can also be connected to the house hot water line ,
as long as it does not exceed a temperature of 60 ℃. In this case, the wash cycle time
will be shortened by about 15 minutes and the wash efficiency slightly reduced.
The connection must be made to the hot water line following the same procedures as those
for the connection to the cold water line. A cold water connection is advised.
Position the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent
cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left to
facilitate proper installation.
20
Insert the drain hose into a drain pipe with a minimum diameter of 4 cm, or let it run into the sink, making sure to avoid bending
or crimping it. Use the special plastic support that comes with the appliance. The free end of the hose must be at a height
between 40 and 100cm and must not be immersed in water.
Once the appliance is positioned, adjust the feet (screwing them in or out) to adjust the
height of the dishwasher, making it level. The appliance should not be slanted more than 2 .
φ 40mm
Drain hose hook
Drain pipe
Front
A
B
C
Attach the drain hose hook to the counter
Counter
NOTE:
The inlet water pressure must be between a Minimum of 0.04 MPa and a maximum of 1.0 Mpa.
