Technical Specifications
Product PL
200F
Maximum Power Output
4W (2 x 2W)
Frequency Response
300Hz – 15kHz (±3dB)
Signal-Noise Ratio
≥
50dB
Driver Units
2inch / 4
Ω
Audio Signal Input
iPod docking slot, 3.5mm stereo jack
FM frequency
87.5 – 108.0 MHz
Power Supply
4 x AA battery or 5V/1.2A power adaptor 100 – 240 Volts
Weight 840g
Dimensions
115mm (L) x 115mm (D) x 115mm (H)
OPERATION
This unit is intended to run from a mains supply of 100-240V 50Hz using the power adapter or 4X AA 1.5V and 1X CR2025
3V Lithium Cell or equivalent batteries.
The PL 200F can be operated by batteries or by power adaptor. Install four AA batteries or insert the power adaptor DC
5Volt lead into the DC IN socket on the back panel of the unit and plug the power adapter into the mains supply. When
inserting the batteries, make sure you observe the battery polarity marking inside the battery compartment. The battery
compartment is located on the back of the main unit.
Switch the unit on with the ON/OFF switch on the back panel of the main unit.
WARNING: Do not mix old and new or different types / makes of batteries, remove all batteries if the unit is not to be
used for an extended period to avoid electrolyte leakage which will damage the unit invalidating the warranty. Do not
dispose of batteries in a fire, danger of explosion.
Standby mode
When PL 200F is switched on, it will enter standby mode. The display will show 00:00 without backlight.
To turn off standby mode (i.e. turn on PL 200F), press SELECT (Press the knob). Press and hold SELECT to enter standby
mode.
The backlight will light when the unit is switched on by pressing SELECT. If no button pressed within 3 seconds, the
display shows the current time with no backlight
Clock Setting
Press SCAN+, the hour digits will flash, turn the knob to set the hour, then press SCAN+ again, the seconds digits will
flash, turn the knob again to set the seconds. Complete the clock setting, by pressing SCAN+ again.
The clock backlight can be turned on by rotating the control knob.
There is a backup battery for the clock. In case of a power cut, the clock is still running internally (there will be no display).
Replace battery when necessary, battery type – CR2025 3V Lithium Cell. The clock backup battery compartment is
located on the back of the unit. You’ll need a small cross head screwdriver to remove the screw holding the clock backup
battery cover in place. Remove the screw and replace the battery then replace the battery cover and retaining screw.
Operation modes – iPod, AUX, FM
In any mode, press SELECT and then rotate the reel clockwise to select the modes.
iPod
Æ
AUX
Æ
FM
Æ
iPod…
