5
INSTALLATION INSTRUCTIONS
Your dishwasher can be installed in various locations in your kitchen as long as there is space and
accessibility to connect your dishwasher to the water/drainage and electrical supply.
NOTE
: The plug must be accessible at all times.
Levelling
Place the dishwasher on an even, stable surface.
It is very important that the dishwasher is perfectly levelled in order to avoid the dishwasher to
malfunction. You can level the dishwasher by adjusting the base feet.
Water Pressure
For best operating results, incoming water pressure should be between 0.04 MPa and 1MPa.
Incoming water supply for the dishwasher is controlled by a ‘pressure switch’, so if the household
water pressure is low, dishwasher fill time will increase or may not operate.
Connecting Your Dishwasher
Inlet hose Drain hose
The water inlet hose from the machine terminates in a 3/4" female connector. The
water supply should therefore terminate in a similar male connector and should
have a stopcock close by in the pipe. It is recommended to connect the machine
to the cold water supply.
Connect the straight connector of the inlet hose to the water supply securely
ensuring that the washers are securely in place at both ends of the hose.
Connect the other end (bent connector) to the water inlet valve at the back of the dishwasher cabinet.
Do not over-tighten to avoid damage to threads.
Attach the drain hose to the wall using the plastic U-bend
fitting provided for this purpose. This end of the hose
should be dropped into a drainage standpipe, the
maximum height of which should be no more than 750mm
above the base of the dishwasher. To allow for an air gap
around the end of the drain hose, the diameter of the
standpipe should be at least 40 mm.
Содержание CDW655P-E
Страница 1: ......
