13
3. Place the dishes on the dish rack and cutlery (unsorted) inside the cutlery basket.
4. Check to make sure that the rotating spray arm can turn freely all the way round. If
necessary remove any obstacles.
5. Fill the detergent in the recessed area on inner door panel. (Approx. 12 grams)
6. Close the door firmly
7. Open the water supply.
8. Push the power (on/off) button.
-Push Button in = power on
-Push Button out = power off
9. select the desired wash program
P1 = Intensive Wash
P2 = Normal Wash
P3 = Rapid Wash
P4 = 3 In 1 Wash (Tablet Wash Program)
P5 = Rinse Wash
(
Note : This is a very short wash program for slightly
soiled dishes )
10. press the start button the display will flash with the selected program.
The power light will be illuminated indicating the machine is receiving power.
11. The dishwasher stops automatically at the end of the program, the display will
stop flashing and the buzzer will Beep (please note that when the machine is in the
drying cycle the machine will seam to be inactive but the program display will remain
flashing this is normal and you must wait until the sounder beeps to indicate the end
of the program) the power light will remain illuminated, until the power (on/off)
button is switched off.
12. The dishwasher is designed to stop if the door is opened accidentally during
operation, re-closing the door will restart the program.
13. After washing, dishes should be allowed to cool down for about 15 minutes so
they are not too hot to handle. Dishes will cool quicker if the door is opened slightly.
Note : when the mains power is connected the display will revert to the default
washing program this default program will change if you use one particular program
more than three times consecutively.
Delayed Start Function
Your dishwasher is equipped with a delayed start function; each press of this button
delays the start of your set program by up to a maximum of 24hr in increments of 1hr
1.
Turn on the power to the dishwasher.
2.
Select the required program.
3.
Press the delay start button two zeros will be displayed continue to press the
button until the required time is set.
