ProLights WDBOX, Руководство пользователя

Страница: 22 / 28

WDBOX 8
To set this product in DMX mode:
1. Connect this product to a suitable power outlet.
2. Connect a DMX cable from the DMX output of the DMX controller to the DMX input socket of this
product.
3.5 OPERATION TRANSMITTER
To connect the WDBOX to a DMX controller and configure it to transmit to compatible lights, do the fol-
lowing:
• Connect the unit to the controller using a DMX cable.
• Connect the hub to power.
If the display shows Transmit Manual and CHXX , where XX is a value between 01 and 16 , the unit is already con-
figured for manual transmission.
• Press the MENU button to access the Settings menu and then press the ENTER button to confirm.
• Use UP/DOWN button to cycle through the highlighted options until the display shows Transmit Manual .
• Press the ENTER button and the display shows Transmit Manual with CHXX highlighted, where XX is a value
between 01 and 16 .
• Use UP/DOWN button to cycle through the highlighted channel options and select the channel to use
for transmission.
• Press the ENTER button and the display shows Transmit Manual and CHXX , where XX is the channel selected
The WDBOX is now configured for manual signal transmission.
NOTE - All the lights must be set to the channel shown on the unit’s display.
3.6 OPERATION RECEIVER
To connect the WDBOX to any DMX lights and configure it to receive signals from a compatible hub, do
the following:
• Connect the hub to the lights using a DMX cable.
• Connect the hub to power.
If the display shows Receive Manual and CHXX , where XX is a value between 01 and 16 , the unit is already con-
figured for manual reception.
• Press the MENU button to access the Settings menu and then press the ENTER button to confirm.
• Use UP/DOWN button to cycle through the highlighted options until the display shows Receive Manual .
• Press the ENTER button and the display shows Receive Manual with CHXX highlighted, where XX is a value
between 01 and 16 .
• Use UP/DOWN button to cycle through the highlighted channel options and select the channel to use
for reception.
• Press the ENTER button and the display shows Receive Manual and CHXX , where XX is the channel selected.
The WDBOX is now configured for manual signal reception.
NOTE - The controller must be set to the channel shown on the unit’s display.
3.7 OPERATION TRANSMIT AUTO/RECEIVE AUTO
To automatically select the channel for communication data refer to the following steps:
• With reference to the preceding paragraphs make connections between units.
• Press the MENU button to access the Settings menu. Press the ENTER button to confirm.
• Use UP/DOWN button to cycle through the highlighted options until the display shows Transmit Auto/
Receive Auto respectively to transmit / receive automatically.
• Press the button ENTER save the setting.
NOTE - Selecting Transmit Auto/Receive Auto automatically detects a transmission/ receiving signal when used
in conjunction with Auto sync.