ProLights SMARTBATHEX, Руководство пользователя

Страница: 12 / 44

SMARTBATHEX 10
• This will turn off all the lights until the button is pressed again.
NOTE - The controller will not respond to any inputs when Black Out is activated. If the remote does not
respond when a button is pressed, try pressing BLACK OUT. You may have inadvertently activated BLACK
OUT.
3.11 MASTER/SLAVE MODE WITH DMX SIGNAL CABLE
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave.
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 16).
• Use any one of the standalone modes for the master unit.
• Set the slaves to the same DMX modes.
3.12 MASTER/SLAVE MODE WITH WIRELESS SIGNAL
This mode allows you to wirelessly connect more units SMARTBATHEX, without a controller. The first unit,
transmitter signal, it will be set as master and the others, receivers, as slave.
Wireless communication between devices can be configured in two ways:
Manual transmit/receive mode
On Master unit:
• Press the MENU button so many times until the display shows S-tr then press the ENTER button.
• Press the UP/DOWN button and select dtCH. Press the ENTER button to confirm.
• Press the UP/DOWN button, select one of the transmitting signal dt 1 - dt 16.
• Press the ENTER button for save the setting.
On Slave unit:
• Press the MENU button so many times until the display shows S-tr. Press the ENTER button to confirm.
• Press the UP/DOWN button and select drCH. Press the ENTER button to confirm.
• Press the UP/DOWN button, select one of the transmitting signal dr 1 - dr 16.
• Press the ENTER button for save the setting.
Auto transmit/receive mode
On Master unit:
• Press the MENU button so many times until the display shows S-tr then press the ENTER button.
• Press the UP/DOWN button and select
dtAS.
Press the ENTER button to confirm.
• Press the ENTER button again to confirm dtAU.
On Slave unit:
• Press the MENU button so many times until the display shows S-tr.
• Press the ENTER button to confirm.
• Press the UP/DOWN button and select
drAS.
• Press the ENTER button to confirm.
• Press the ENTER button again to confirm drAU.
On Master unit:
• Hold the AUTO button.
On Slave unit:
• Hold the AUTO button (always hold AUTO button on Master unit).
• Wait 5 seconds and release the AUTO button on Slave unit.
NOTE - Use any one of the standalone modes for the master unit. Set the slaves to the same DMX modes.