ProLights LUMIPIX16H, Руководство пользователя

Страница: 33 / 48

11
LUMIPIX16H
3.4 AUTO SHOW MODE
If no DMX control signal is present at the DMX INPUT, the unit independently runs through its show pro-
gramme provided that the blackout mode is switched off:
• Press the button MENU so many times until the display shows [AUTO] , then press the button ENTER.
• Press the button UP/DOWN to switch between the show ( AUTO 0 - AUTO 12 ). The unit will operate in show
mode.
• Using the button UP/DOWN to select the desired run speed slow-fast [0-100]
• Press the button ENTER to save the setting.
IMPORTANT: Programs AUTO 0 - AUTO 12 are fully pre-programmed and will not be altered by changes. In-
stead, MANU C mode allows to combine the colors RGBWAP .
• Press the button MENU so many times until the display shows
[STATIC]
, then press the button ENTER.
• Through the button UP/DOWN select [MANU C] , then press the button ENTER.
• Select the color [R-G-B-A-W-P] through the buttons UP/DOWN.
• Press the button ENTER to confirm.
• Set the value (000 - 255) , through the buttons UP/DOWN.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
3.5 STATIC MODE
This fixture has the ability to accept custom static color settings. Access these chases via the control panel
on the back of the fixture.
• To enable the static mode, press MENU repeatedly until [STATIC] shows on the display.
• Press the button ENTER.
• Through the button UP/DOWN select [FIXT C] , then press the button ENTER.
• Select the desired preset color [R - G - B - A- W - P - RB - RG ecc.] using the button UP/DOWN.
• Press the button ENTER to save the setting.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
3.6 MASTER/SLAVE MODE
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave with the same effect.
• Press the button MENU so many times until the display shows [M & S] and press the button ENTER.
• Press UP/DOWN to set the unit as master or slave (MASTER, SLAVE) .
• Select the desired program (see section 3.4).
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 13).
3.7 LINKING
Several units may be interconnected in order to control all further slave units to the same effect of the
master unit.
1. Connect the DMX OUT of the master unit via 3/5-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.