ProLights EXPLO3000D, Руководство пользователя

Страница: 24 / 36

EXPLO3000D
6
- 2 - INSTALLATION
2.1 LAMP
We recommend that you use 3000W Xenon lamp. Make sure that the lamp you use is compatible with
local voltage.If the lamp is operated with a voltage surpassing its nominal operating voltage, it can be
damaged or its service life reduced considerably
2.2 LAMP POWER SETTING
The EXPLO3000D provides high and low lamp power settings. The high power setting provides maximum
flash intensity; the low power setting reduces output and extends lamp life. The setting is selected on pin
6 of the Mode DIP switch and applies regardless of the other switch settings.
2.4 MOUNTING
The EXPLO3000D can be fixed (as shown below) using the mounting bracket screws or using the dedi-
cated lighting support if mounted on a crossbeam. The mounting place must be of sufficient stability and
be able to support a weight of 10 times of the unit’s weight.
When carrying out any installation, always comply scrupulously with all the regulations (particularly re-
garding safety) currently in force in the country in which the fixture’s being used.
• Install the projector at a suitable location by means of the mounting bracket.
• Always additionally secure the projector with the safety rope from falling down. For this purpose, fas-
ten the safety rope at a suitable position so that the maximum fall of the projector will be 20 cm.
• Adjust the projector and use the knob to slightly release or tighten the locking mechanism of the
bracket if is necessary.
2.3 INSERTING OR REPLACING THE LAMP
ON/ OFF state of the can be shown with Flash LED on the rear panel.
1. Disconnect the fixture from AC power and allow the capacitor to discharge for 1 minute.
2. When the fixture is cool, remove the two marked screws on the sides of the fixture and open the front
glass cover.
3. Disconnect the lamp wires at the screw terminals. Lift the old lamp out of the holder.
4. Replace a new lamp instead of the old.
5. Lift and turn the lamp over so that the leads loop around the ends as shown, then press the lamp into
the clips.
6. Close the front cover and tighten the side screws before applying power.
Fig.2
HIGH POWER SETTING LOW POWER SETTING
Fig.3