ECLIPSEHD2
11
3.7 STATIC MODE
This fixture has the ability to accept custom static color settings. Access these chases via the control panel
on the back of the fixture.
• To enable the static mode, press MENU repeatedly until
STATIC
shows on the display.
• Through the button UP/DOWN select
DIMMER
or
STROBE
then press the button ENTER.
• Set the value (
000 - 255
), through the buttons UP/DOWN.
• Press the button ENTER to confirm.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
3.8 AUTO SHOW MODE
If no DMX control signal is present at the DMX INPUT, the unit independently runs through its show pro-
gramme provided that the blackout mode is switched off:
• Press the button MENU so many times until the display shows AUTO, then press the button ENTER.
• Press the button UP/DOWN to switch between the show
AUTO 1 - AUTO 4
. The unit will operate in show
• mode.
• Using the button UP/DOWN to select the desired run speed slow-fast (
0-100
)
• Press the button ENTER to save the setting.
• IMPORTANT: Programs
AUTO 1 - AUTO 4
are fully pre-programmed and will not be altered by changes.
3.9 MASTER/SLAVE MODE
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave with the same effect.
• Press the button MENU so many times until the display shows
MASTER/SLAVE
and press the button ENTER.
• Press UP/DOWN to set the unit as master or slave
(MASTER, SLAVE)
.
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 13).
3.10 DIMMER MODE
Enter in Dimmer mode to select specific dimming curve, press the button MENU so many times until
shows
DIM MODE,
and press the button ENTER to confirm.
• Press the button UP/DOWN to select
OFF - DIM1 - DIM2 - DIM3.
• Press ENTER button to store.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
3.11 LED FREQUENCY
To adjust the frequency of the LEDs, press the MENU button repeatedly until the display shows
LED Fre-
quency,
and then press the ENTER button.
• Select the frequency
(600Hz - 1200Hz - 2000Hz - 4000Hz - 25kHz)
using the UP/DOWN buttons.
• To confirm, press the ENTER key.
• Press the MENU button to go back or wait a few seconds to exit the setup menu.
3.12 FAN MODE
To set the Fan Mode press the button MENU so many times until shows
FAN MODE,
and press the button
ENTER to confirm.
• Press the button UP/DOWN to select
AUTO - HIGH.
Содержание ECLIPSEHD2
Страница 34: ...Note ...
Страница 35: ......