ProLights ECLIPSE FRESNEL DY, Руководство пользователя

Страница: 27 / 32

11 ECLIPSEFRESNELTU-DY
3. 8 FIXTURE SETTINGS
It is possible to change the parameter value in the following way:
DIMMER
• Enter in Dimmer mode to select specific dimming curve, press the button MENU so many times until
shows DIM MODE, and press the button ENTER to confirm.
• Press the button UP/DOWN to select OFF - DIM1 - DIM2 - DIM3.
• Press ENTER button to store.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
LED FREQUENCY
• To adjust the frequency of the LEDs, press the MENU button repeatedly until the display shows
LED
Frequency, and then press the ENTER button.
• Select the frequency (600Hz - 1200Hz - 2000Hz - 4000Hz - 6000Hz - 25kHz) using the UP/DOWN buttons.
• To confirm, press the ENTER key.
• Press the MENU button to go back or wait a few seconds to exit the setup menu.
FACTORY RELOAD
Selezionare questa funzione per ripristinare l’unità alle impostazioni di fabbrica:
• To activate Reset Factory display press the button MENU so many times until shows Factory
Reload
,
and press the button ENTER to confirm.
• Press ENTER button to confirm the selection.
• Press the MENU button to go back or to meet the waiting time to exit from the setup menu automati-
cally.
3. 9 FIXTURE INFORMATION
To view all the information on the device, proceed as follows:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the icon Information, then press the ENTER but-
ton to enter the next menu.
• Press the UP/DOWN button to scroll through the menu, then select one of the following information
and press the ENTER button to display it.
- Fixture Time - Through the Fixture Time function you can display the operating time of the projector.
- Software Version - Through Version function you can display the currently installed software version.
• Press the LEFT button repeatedly to exit the menu.
3. 10 OPERATIONS IN AUTOMATIC MODE
MASTER SLAVE
Press the UP/DOWN button to scroll through the menu, select Master/Slave and press ENTER to confirm your
choice.
• Press the UP/DOWN button to select the mode of operation:
- Master , if the unit is connected in series with other units and it acts as the Master;
- Slave , if the unit is not connected to other units.
• Press the ENTER button to confirm your choice.
EFFECTS
The unit independently runs through its show. Before you send an automatic program you need to set the
drive as Master/Alone:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the Effects icon, then press the ENTER button to