ProLights DOTQ, Руководство пользователя

Страница: 28 / 32

doTQ
12
"
"
3.9 CHANNELS DMX
- 4 - MAINTENANCE
4.1 MAINTENANCE AND CLEANING THE UNIT
• Make sure the area below the installation place is free from unwanted persons during setup.
• Switch off the unit, unplug the main cable and wait until the unit has cooled down.
• All screws used for installing the device and any of its parts should be tightly fastened and should not
be corroded.
• Housings, fixations and installation spots (ceiling, trusses, suspensions) should be totally free from any
deformation.
• It is recommended to clean the front at regular intervals, from impurities caused by dust, smoke, or
other particles to ensure that the light is radiated at maximum brightness. For cleaning, disconnect the
main plug from the socket. Use a soft, clean cloth moistened with a mild detergent. Then carefully wipe
the part dry. For cleaning other housing parts use only a soft, clean cloth. Never use a liquid, it might
penetrate the unit and cause damage to it.
STD EXT
FUNCTION DMX
Value
5ch 9ch
1 1
DIMMER
0~100% 000 - 255
2 2
RED
0~100% 000 - 255
3 3
GREEN
0~100% 000 - 255
4 4
BLUE
0~100% 000 - 255
5 5
WHITE
0~100% 000 - 255
6
MACRO
Black ~ Yellow 000 - 255
7
FADING
On Function
Color Function
Rainbow
Rainbow (Plus White) 000 - 031
032 - 095
096 - 191
192 - 255
8
FADING SPEED
Speed slow to fast 000 - 255
9
SHUTTER
Strobe rate (slow to fast)
000 - 255
3.10 RDM - Remote Device Management
This device is RDM ready. RDM stands for “Remote Device Management” and makes remote control of
devices connected to the DMX-bus possible. Manual settings like adjusting the DMX starting address are
no longer needed. This is especially useful when the device is installed in a remote area. If DMX splitters
are used and RDM control is to be used, these splitters must support RDM. The number and type of RDM
parameters depend on the RDM controller (not included) is used.
You can control DOTQ with RDM protocol using a RDM READY transmitter (BLACKBOXF1G4MK2) and a
RDM controller or software.
Default DMX mode: STANDARD 5ch - To change the DMX mode in EXTENDED 9ch use a RDM WIRELESS
transmitter and a RDM controller. (info: support@musiclights.it)