ProLights Diamond 193, Руководство пользователя

Страница: 32 / 40

12
DIAMOND193
3.6 Slave mode
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave with the same effect.
• Press the button FUNC so many times until the display shows [ SLA ] (fig.7).
• Press ENTER button to confirm the selection.
• Select the desired operation mode (see section 3.4)
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 13).
3.7 Linking
Several units may be interconnected in order to control all further slave units to the same effect of the
master unit.
1. Connect the DMX OUT of the master unit via 3-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units are
connected in a chain.
3.8 DMX mode
• Press the button FUNC so many times until the display shows the DMX address (fig.8).
• Press the buttons UP and DOWN to select the desired value (001 - 511).
• After the setting value for to confirm, press the button ENTER.
Fig.7
FUNC UP DOWN ENTER
3.9 DMX addressing
To able to operate the DIAMOND193 with a light controller, adjust the DMX start address for the first a DMX
channel. If e. g. address 33 on the controller is provided for controlling the function of the first DMX chan-
nel, adjust the start address 33 on the DIAMOND193. The other functions of the light effect panel are then
automatically assigned to the following addresses.
Fig.8
FUNC UP DOWN ENTER