ProLights ARENACOB4HALO, Руководство пользователя

Страница: 32 / 44

ARENACOB4HALO
12
• Press the UP/DOWN button and select [Master] to set the drive as a master.
• Press the ENTER button for save the setting.
3.11 LINKING
• Connect the DMX OUT of the master unit via 5-pole XLR cable to the DMX IN of the first slave unit.
• Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.
3.12 DMX MODE
• Press the MENU button so many times until show Dmx Channel and press ENTER to confirm.
• Press the UP/DOWN button to select the desired DMX mod.
• Press ENTER button to store.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu
3.13 DMX ADDRESSING
• Press the MENU button so many times until show Dmx Address and press ENTER to confirm.
• Press the UP/DOWN button to select the desired DMX address 001 - 512. Press and hold to scroll quickly.
• Press ENTER button to store.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu
3.14 RDM - Remote Device Management
With this function you can call up various submenus via RDM.
This device is RDM ready. RDM stands for “Remote Device Management” and makes remote control of
devices connected to the DMX-bus possible. Manual settings like adjusting the DMX starting address are
no longer needed. This is especially useful when the device is installed in a remote area. RDM is integrated
in DMX without influencing the connections. The RDM-data is transmitted via the standard XLR-poles 1
and 2 – new DMX-cables are not necessary. RDM ready and conventional DMX devices can be operated
in one DMX line. The RDM protocol sends own packages in the DMX512 data feed and does not influence
conventional devices. If DMX splitters are used and RDM control is to be used, these splitters must sup-
port RDM. The number and type of RDM parameters depend on the RDM controller (not included) is used.