ProLights ARCLED7314TRITZ, Руководство пользователя

Страница: 42 / 50

ARCLED7314TRITZ
18
3.18 White calibration
Enter the CAL1 mode to select white color of different color temperature;
• Press the button MENU so many times until show [ CAL1 ] and press the button ENTER to confirm.
• There are 11 pre-programmed white colors ( WT01 - WT11 ) can be edited by using red, green and blue ( Red
- Green -Blue ).
• Set the value ( 000 - 255 ), through the buttons UP and DOWN.
3.19 RGB calibration
Enter the CAL2 mode to adjust the RGB parameter to make different whites;
• Press the button MENU so many times until show [ CAL2 ] and press the button ENTER to confirm.
• Select red, green or blue ( Red - Green -Blue ), through the buttons UP and DOWN. Press the button ENTER
to confirm.
• Set the value ( 000 - 255 ), through the buttons UP and DOWN.
When the new setting is activated, the DMX controller choose RGB=255, 255, 255 the write color will be
made by actual RGB values on the [
CAL2 ].
3.20 Activate the password
Enter the KEY mode to select whether the access password is on or off.
• Press the button MENU so many times until show [ KEY ] and press the button ENTER to confirm.
• Select [ ON ] or [ OFF ].
When the fixture is set as pass [ ON ], after 30 seconds or turn on the fixture next time, the fixture will need an
access password to enter the display menu control.
Note. The factory access password is UP + DOWN + UP + DOWN. Press ENTER to confirm the access.
- 4 - MAINTENANCE
4.1 Cleaning the unit and maintenance
• Make sure the area below the installation place is free from unwanted persons during setup.
• Switch off the unit, unplug the main cable and wait until the unit has cooled down.
• All screws used for installing the device and any of its parts should be tightly fastened and should not
be corroded.
• Housings, fixations and installation spots (ceiling, trusses, suspensions) should be totally free from any
deformation.
• The main cables must be in impeccable condition and should be replaced immediately even when a
small problem is detected.
• The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
• It is recommended to clean the front at regular intervals, from impurities caused by dust, smoke, or other
particles to ensure that the light is radiated at maximum brightness. For cleaning, disconnect the main
plug from the socket. Use a soft, clean cloth moistened with a mild detergent. Then carefully wipe the
part dry. For cleaning other housing parts use only a soft, clean cloth. Never use a liquid, it might pen-
etrate the unit and cause damage to it.
Warning: we strongly recommend internal cleaning to be carried out by qualified personnel!