ProLights 6BEAMQ, Руководство пользователя

Страница: 29 / 40

9
6bEAMQ
3.4 AUTO SHOW
This fixture has a built-in automatic program. To access this, please see the below instructions:
• Press the button MENU so many times until shows P-- , then press the button ENTER.
• Using UP/DOWN button, select one of the programs P0 - P10 .
• Press the button ENTER to confirm.
• Press the button MENU until
S--
appears on the display.
• Use the button UP/DOWN to select the auto programs speed S001 - S100 (slow-fast).
• Press the button ENTER save the setting.
3.5 STATIC COLOR
This fixture has the ability to accept custom static color settings. Access these chases via the control panel
on the back of the fixture.
• Press the button MENU so many times until shows C-- , then press the button ENTER.
• Using UP/DOWN button, select one of the programs C1 - C15 .
• Press the button ENTER to confirm.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
3.6 MANUAL COLOR
This mode allows to combine the colors red, green and blue
r, g, b, W
.
• Press the button MENU so many times until the display shows U-- , then press the button ENTER.
• Select the color r, g, b,W through the buttons UP/DOWN.
• Press the button ENTER to confirm.
• Using UP/DOWN button, select the desired color value 000 - 255 .
• Press ENTER button to continue to the next color.
• Continue until the desired mix is obtained.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
3.7 SOUND MODE
In music mode, the 6BEAMQ can be controlled by music with a clear rhythm in the bass range. If the music
control should not work optimally, increase the volume or reduce the distance of the sound source.
• Press the button MENU so many times until the display shows Snd .
• Press the button ENTER.
• You can set the microphone sensitivity pressing the button MENU so many times until the display show
SenS.
• Using the button UP/DOWN, select the desired value sensitivity (slow-fast) u0 - u100 .
• Press the button ENTER to confirm.
3.8 MASTER/SLAVE MODE
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave.
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 11).
• Set on master fixture the desired program (see section 3.4).
• Set the slaves to the same DMX modes.