Prolight LEDSOFT 18, Руководство пользователя

Страница: 13 / 28

11
LEDSOFT18
- 3 - THE CONNECTIONS
There are power cable and signal cable at the back of every LEDSOFT18 screen, after fixing well the LED-
SOFT18 screen, please connect them correctly as following picture.
3.1 TO CONNECT THE POWER CABLE
There is power wire at the back of the LEDSOFT18 screen. When finishing installation, make sure the power
wire is connected correctly and turn on the power supply, the input power is AC 90V ~260V 50~60Hz,
which must be contacted with ground to ensure the safety of the whole system.
3.2 TO CONNECT THE SIGNAL CABLE
Connect the signal wire between LEDSOFT18 screen and Receiver
There are signal wire with 15pin plug at one side of the LEDSOFT18 screen, from up to down,connect them
with the signal cable on the receiver one by one, then lock the nut on the plug. At the right sides of the
LEDSOFT18 screen, there is a output power wcable signed DC 5V, connect it with receiver.
Connect the signal wire between LEDSOFT18 screen
Connect the signal wire one by one between two curtain nearby, lock the nut on the plug.
Caution
The function of the button is just to combine several piece into one, but not to load too much weight,
must not connect many display just by button if not, there may be following result.
• Breaking the button;
• Breaking LEDSOFT18 screen;
• Falling off the LED screen cause other unsafe affair.
Fig.7
DC 5V
To receiver
AC 90-260V