Montageanleitung /
Installation manual
MBN GmbH, Balthasar-Schaller-Str. 3, 86316 Friedberg - Germany
www.proled.com
1-10V & 10 kOhm potentiometer
– L50002D1:
1-10V or 10 kOhm potentiometer =
1V = 0%, 10 V = 100 %
Remarks:
The device allows you to vary the luminious intensity from 0
– 100%.
For brightness levels <10%ignition of luminaires driven can not be clearly visible.
This depends on the ambient light and the luminaire features.
In standard the automatic signal detection is enabled. As long as the voltage between 3V and 7V exists or
potentiometer is between 30% and 70%, the corresponding signal control will be activated.
The N. O. push button will be detected after 5 clicks in short time. In PUSH-DIM-mode is the memory
function always enabled.
PUSH-DIM menu:
Following settings are possible:
Minimum dimming
Fade-In
Fade-Out
Minimum dimming: Each single click change the setting. You can choose 7 settings:
0,1 %, 1%, 5%, 10%, 20%, 30% und 100%.
After choosing of setting, please press long for saving. The luminaire flash 2 times for
confirmation and you can continue with next menu.
Fade-In:
Each single click change the setting. You can choose 6 settings:
immediately, 1 second, 2 seconds, 3 seconds, 6 seconds.
After choosing of setting, please press long for saving. The luminaire flash 3 times for
confirmation and you can continue with next menu.
Fade-Out:
Each single click change the setting. You can choose 5 settings:
immediately, 1 second, 2 seconds, 3 seconds, 6 seconds.
After choosing of setting, please press long for saving. The luminaire flash 3 times fast
for confirmation and you can continue with next menu.
After leaving the menu, the connected luminaire turns on with the minimum dimming setting.
Connection diagram:
05.20 Technical amendments reserved
Only L50002D1
Only L50002X1
