
6
CHARGING & ENGINE START INSTRUCTIONS
STEP 1 – CHECK THE ELECTROLYTE LEVEL
Prior to charging the battery, remove the vent caps and check the electrolyte level. (Not required on
sealed & maintenance free batteries). The electrolyte should be 6mm (1/4”) above the battery’s plates.
If low, top up the electrolyte with distilled water to the correct level and refit the vent caps.
STEP 2A – CONNECTION OUT OF VEHICLE
Connect the RED lead (battery clip) from the charger to the Positive (+) battery post.
Connect the BLACK lead (battery clip) from the charger to the Negative (-) battery post.
CONNECTION OUT OF VEHICLE
6/12/24 VOLT 12 AMP AUTOMATIC BATTERY CHARGER WITH ENGINE START
WORKSHOP 1200
HDBC20 Instruction Manual NEW_Layout 1 28/07/11 4:33 PM Page 7