HOW TO ORDER
1.800.676.6123 |
sales@progressiveautomations.com
|
www.progressiveautomations.com
MODIFIYING LED DISPLAY
Press the DOWN button on the Hand Remote until the base reaches its lowest position.
Measure the height of the base from the floor and if the number on the LED display does
not match your measurements, follow the steps below:
Press and hold the DOWN button again until the LED display reads "RST".
Press and hold the "M" button for about 5 seconds until the LED displays the flashing
starting height.
To change the value of the starting height:
Increase by 0.1s, press the UP button
Decrease by 0.1s, press the DOWN button
Increase by 1s, press the "1" button
Decrease by 1s, press the "2" button
Increase by 10s, press the "3" button
Decrease by 10s, press the "4" button
Once the new value is displayed, wait about 5 seconds and the display will return to
"RST". Finish the reset process by pressing and holding the DOWN button again until
the desk lowers a little bit more, slightly rises and stops. Release the DOWN button and
the new starting height value is saved.
