Progressive Turf Equipment TDR-X, Руководство оператора и список запчастей

Страница: 24 / 75

TDR-X
Operator’s Manual
22
4.1. If one deck does not move, STOP, release the pull rope and
fully raise the decks again. Repeat step 1.
5. If all decks lower, continue lowering the decks to the ground.
6. Once the decks touch the ground, hold the lever and ensure all three
cylinders are fully extended
As with any mechanical system, the lock system needs to be used and
maintained properly. With only a few moving parts, this is a simple task.
In a safe level location, fully lower the decks to the ground, shut the
tractor engine off, and set the parking brake.
With the lock rope released, all three lock arms should lay flat, resting
against the
3/8” bolts. This is critical for proper function of the Pro Lift-N-
Turn
™ system.(Figure 5)
Check each of the three lock arms and release cams making sure they
do not bind when the lock release rope is pulled or released.
Ensure that the lock arms, release cams, cables and springs are in good
condition and move freely.
Check to see if the lock release pull arm is free to rotate without binding
and returns to a neutral position so that the deck lock arms can lay flat
against the wing frame.
If any binding or damage is found, repair the issue before proceeding to
use the mower
TRANSPORT LOCK
When the decks are in the fully raised position and the pull rope released
(slack), the lock arms engage with each wing and the rear lift to ensure
they do not lower when hydraulic pressure is relieved. (Figure 6)
Never stand beneath the mower decks when placed in the
transport position.
Pro Lift-N-Turn
TM
Position
Figure 5
Lock Pin
Locked Transport Position
Figure 6