Progressive Turf Equipment TD 92, Руководство оператора

Страница: 13 / 73

TD92
Operator’s Manual
11
•
Keep away from overhead electrical lines. Electrocution can occur
without direct contact
•
Clean reflectors, Slow Moving Vehicle sign and lights before
transporting. Use power unit hazard lights.
•
Before disconnecting from power unit, always place controls in
neutral, set park brake, turn engine off, and wait for all moving
parts to stop. Relieve hydraulic pressure per power unit
manufacturer’s instructions.
•
Ensure mower parking jack is securely fastened to mower frame
with supplied pin before removing hitch draw pin.
MAINTENANCE SAFETY PRECAUTIONS
•
Never make adjustments or repairs with the engine running. Always
disengage PTO, engage parking brake, turn engine off, lower wings to
cutting position and relieve hydraulic pressure before performing any
maintenance.
•
Observe and perform proper lock-out procedures for power unit if
attached to mower during service.
•
Keep nuts and bolts tight and properly torqued, especially blade
attachment bolts. Check that all cotter pins are properly installed.
Keep equipment in good condition.
•
Keep mower free of grass, leaves, or other debris build-up.
•
Never work on raised mower decks without safety locks in place.
•
Periodically check condition of safety devices, guards, and deflectors.
Replace only with manufacturer’s recommended parts.
•
Inspect and replace damaged blades. Use only original OEM parts.
Blades can fail from poor maintenance practices.
•
Handle mower blades carefully. They are sharp and can cut
unprotected skin. Use caution and wear gloves when handling them.
•
Check to make sure hydraulic hoses are not worn or damaged, and
are routed to avoid chafing.
•
Immediately replace any hydraulic hose that shows signs of swelling,
wear, leaks or damage so it does not burst.
•
Do not use your hand to check for hydraulic oil leaks. Use a piece of
cardboard instead.
•
Hydraulic fluid escaping under pressure can penetrate the skin
causing serious injury. If skin penetration occurs, seek medical
attention immediately. Relieve all pressure before disconnecting
hoses.
•
Do not bend or strike hydraulic lines, tubes or hoses, or reinstall them
in a bent or damaged condition.
•
Inspect tires daily for wear or damage. Check tire pressures weekly
with an accurate pressure gauge. Do not inflate tires beyond 35 psi.
•
Mounting and dismounting tires from rims can be dangerous and
should be performed by trained personnel using correct tools,
equipment and procedures.