Progressive Dynamics PD2020 Скачать руководство пользователя страница 6

-11-

7.

MAINTAINING THE

 

INTELI-POWER MARINE

CONVERTER/CHARGER

7.1

No adjustments or maintenance is required for the 

INTELI-POWER

MARINE

 converter other than periodically checking all electrical

connections for tightness by a qualified service person.

CAUTION

Check battery water level frequently, especially if boat is
at dock for extended periods of time. Low water levels
will damage batteries!

TROUBLESHOOTING THE 

 

INTELI-POWER MARINE  CONVERTER/CHARGER

TROUBLE SHOOTING GUIDE

PROBLEM

POSSIBLE CAUSES

ACTION

1. No Output

120 VAC supply not
connected

Connect power supply

Check AC distribution panel for
proper operation

Internal Fuse(s) Blown

Check for Reverse Polarity
Replace Fuse(s) with same type
and rating

Short Circuit

Trace Vessel Circuits for possible
fault

Unit has shutdown due
to overheating

Check air flow

Allow unit to cool

Unit has shutdown due
to over voltage

Check input voltage

Converter will shut down if the
input voltage exceeds 132 Volts
Correct Input Voltage

2. Internal Fuse(s)
Blown

Reverse Battery Hook
Up

Correct Hook up and replace
Fuse(s) with same type and rating

3. Converter
cycles on & off

Compartment gets too
hot

Check air flow to the converter

Improve Ventilation to the
compartment

4. Low Output

Excessive Load for
Converter

Reduce load requirements or
Install Larger Converter

Input Voltage not
between 105-130 VAC

Correct input supply voltage

Bad Battery Cell(s)

Replace Battery

-12-

SAMPLE WIRING DIAGRAMS FOR SERIES/PARALLEL CONNECTIONS.

The Inteli-Power chargers can be wired in series to provide a 24 volt charging system. 
They can also be wired in parallel to provide additional charge current.

Parallel Connection:

Wiring the Inteli-power chargers as shown below will provide additional charging

current to the 12 volt house battery system and eliminates the need to install additional
chargers for the engine, generator and the 12 volt bow thruster batteries.

The Parallel system shown above using PD2050 Chargers can provide a maximum of
100 amps to recharge the house battery system.  It can also provide up to 50 amps to
charge the engine, bow thruster or generator batteries if the house batteries are fully
charged.

Содержание PD2020









Отзывы: