Page 2
USER’S GUIDE
Warning:
Correct installation is extremely essential , and falls outside the scope of responsibility of
manufacturer . The user must pay attention to the weight of TV and TV bracket , and only solid
wall can support the weight . Please complied with the installation instruction of LCD/PDP to install
them .
3.Installation Instruction
3-1.Installation Method:
1.
Firstly,please make sure the wall thickness
for TV wall mount is at least 80mm and the
position where you want to install the TV
do not have any rigid materials(such as :
reinforcing steel bar , steel block ,etc ) and any
loose phenomena , put the bottom plate to the wall , keep it
horizontal and mark hole locations and drill hole to 60~70mm
depth,then take out plastic wall plugs(3pcs) from the parts
bag and put them to the holes of wall. Finally, use self-
tapping screws (3pcs)to install the bottom plate to the wall
and check the fastness. (See diagram 1)
2.
Install TV to the holes of TV bracket by washers M5 (4pcs)
and round head screws (4pcs). (See diagram 2)
3.
Hang the TV bracket with TV to the bottom plate,then use
round head screws(M6 2pcs) to tighten two sides of bottom
plate. Finally , insert the end of adapter into the power supply
interface. (See diagram 3)
3-2.Operation Instruction
A. Function
This product can be remote controlled to adjust TV panel angle 15 each to
pitch up or down ,or turn left or right. (See diagram 4 )
B. Remote Control:(see diagram 5)
I. Key Function
1.
Up : Hold on to pitch TV up.
2.
Down : Hold on to pitch TV down.
3.
Left : Hold on to turn TV left.
4.
Right : Hold on to turn TV right.
Diagram 3
