6. Assemble the filter (
A
) and put it into
position in filter (
B
). Turn it clockwise
until it locks.
An incorrect position of the filters can
cause bad washing results and dam-
age to the appliance.
Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged,
remove remaining parts of soil with a thin
pointed object.
External cleaning
Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning pads
or solvents.
TROUBLESHOOTING
The appliance does not start or it stops
during operation.
Before you contact the Service, refer to the
information that follows for a solution to the
problem.
With some problems, different indica-
tors flash continuously or intermittently
at the same time to show an alarm
code.
Alarm code
Problem
• The start indicator flashes continuously.
• The end indicator flashes 1 time intermittently.
The appliance does not fill with water.
• The start indicator flashes continuously.
• The end indicator flashes 2 times intermittent-
ly.
The appliance does not drain the water.
• The start indicator flashes continuously.
• The end indicator flashes 3 times intermittent-
ly.
The anti-flood device is on.
Warning!
Deactivate the appliance
before you do the checks. Turn the
programme knob until the programme
marker is aligned with the on/off
indicator.
Problem
Possible solution
You cannot activate the appliance.
Make sure that the mains plug is connected to the
mains socket.
Make sure that there is not a damaged fuse in the fuse
box.
The programme does not start.
Make sure that the appliance door is closed.
If the delay start is set, cancel the setting or wait for the
end of the countdown.
The appliance does not fill with water.
Make sure that the water tap is open.
progress
23
