Progress PK0841, Руководство пользователя

Страница: 19 / 48

Problem Possible cause Solution
Products prevent that water
flows into the water collector. Make sure that products do not
touch the rear plate.
Water flows on the
ground. The melting water outlet does
not flow in the evaporative tray
above the compressor. Attach the melting water outlet to
the evaporative tray.
The temperature in the
appliance is too low. The temperature regulator is not
set correctly. Set a higher temperature.
The temperature in the
appliance is too high. The temperature regulator is not
set correctly. Set a lower temperature.
Replacing the lamp
1. Disconnect the mains plug from the
mains socket.
2. Remove the screw from the lamp cov-
er.
3. Remove the lamp cover (refer to the il-
lustration).
4. Replace the used lamp with a new
lamp of the same power and specifical-
ly designed for household appliances.
(the maximum power is shown on the
lamp cover).
5. Install the lamp cover.
6. Tighten the screw to the lamp cover.
7. Connect the mains plug to the mains
socket.
8. Open the door. Make sure that the
lamp comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
TECHNICAL DATA
Dimension of the recess
Height 880 mm
Width 560 mm
Depth 550 mm
Voltage 230 V
Frequency 50 Hz
The technical information are situated in the
rating plate on the internal left side of the
appliance and in the energy label.
progress 19