5
Textile dust bag (fig. 14-17)
Remove the textile bag from the holder. Slide the
plastic clip away from the bag to open and empty.
Replace the plastic clip ensuring that both sides of
the bag are parallel. Replace the bag into the hold-
er. Note: The bag may be washed in luke warm
water and dried completely. It should not be washed
in washing machine. Close the cover by pressing
down until it clicks.
Cleaning/Changing the
motor protection filter (fig. 18-20)
Pull dustbag upward and remove the motor protec-
tion filter with grill. Remove the filter from the grill.
Rinse the filter under tap water and dry it complete-
ly. Place the filter back into the grill and put it back
into the cleaner.
We recommend replacing the motor protection filter
at each fifth paper filter replacement, and at the lat-
est when there is a clean dust bag and the dust level
indicator is completely red with the nozzle raised.
Open the lid and fold up. Remove the used filter and
dispose of it with the household waste. Insert the
new filter and close the cassette.
Cleaning/changing the microfilter (fig. 21-23)
Open the filter grill to remove the exhaust filter. Take
the filter out of the grill. Rinse the filter under tap
water and dry it completely. Place the filter back into
the grill. Close the filter grill.
Cleaning
As required, wipe the housing and the paper filter
compartment with a damp cloth. Do not use any
scourers or any solvents. Occasionally vacuum the
floor nozzle and brushheads with the crevice nozzle.
Paper filter
Progress P67
Carrying and Storage
Parking System (fig. 24)
For storing the suction pipe and nozzle during short
pauses in vacuuming. The bracket on the nozzle is
slid into the parking rail on the appliance.
What do I do, if ...
... it is difficult to push the nozzle
Reduce the power setting on the appliance. This will
not reduce cleaning efficiency.
... the motor thermal cut-out is activated
If the motor is overloaded, e.g. due to a full filter bag
or blocked accessory, the thermal cut-out shuts
down the motor. In this case, switch off the appli-
ance, unplug from the mains, and leave the motor to
cool down. Check paper filter bag, suction tube and
suction hose; remove any blockage. The appliance
can be switched on again after approximately 30
minutes.
... the fuse has blown
The fuse may blow if you use other electrical appli-
ances with high power consumption on the same
electric circuit at the same time as the vacuum
cleaner is in use. This can be avoided if you set the
electronic power adjuster to the lowest power level
and then select a higher level after switching the
appliance on.
Your vacuum cleaner can be fitted with a gentle
start-up control which reduces the starting current to
the motor and therefore prevents the electric circuit
cut-out being triggered under normal conditions. It is
possible that there will be a delay of about 4 sec-
onds in the appliance starting up on the lowest
power level.
… the paper filter is damaged at some stage
and the motor protection filter is dirtied
Remove the filter, clean (tap out) and replace. Insert
new paper filter.
Preparing the
vacuum cleaner for use
The accessories can be connected by pushing and
twisting, and can be disconnected by pulling them
apart and twisting.
1. Connecting the suction hose and suction
tube.
Join the suction hose handle firmly to the suction
tube.
2. Adjust the Telescopic Tube
Push down the button on the tube and adjust the
tube to the desired working position.
3. Attaching the suction hose
Insert the suction hose connector in the suction inlet.
It locks in place and can be rotated all the way
around. Press the release button and pull out the
connector in order to remove the suction hose.
4. Mains connection/Cable rewind
The mains cable is in the cable compartment. Pull
out the cable and insert the plug into the mains sock-
et. Remove plug from the mains socket. Press the
foot button; the cable rewinds automatically when
vacuuming has been completed.
Using the nozzles
5. Using the floor nozzle
For the daily care of carpets and hard floors.
Without being changed over manually, the floor noz-
zle is entirely suited for daily vacuuming of carpets
and hard floor surfaces such as parquet, tiles,
linoleum, etc. The floor nozzle may be changed over
manually. The brushes can be extended for smooth
floors and retracted for carpets.
Crevice and upholstery nozzle
For specific cleaning requirements, two additional
parts are included with the vacuum cleaner.
The nozzles may be attached to the suction tube or
the handle on the suction hose, depending on
requirements.
6. Crevice nozzle
For vacuuming crevices, gaps and corners.
7. Upholstery nozzle
For vacuum cleaning all upholstered furniture, mat-
tresses, etc. The thread lifting strips on the nozzle
even pick up thread and lint.
Switching on
8. Switching on and off
You can switch the appliance on and off by pressing
the On/Off button.
Power adjustment:
9. Power adjustment - Rotary control
The suction power can be varied to suit individual
vacuuming requirements using the electronic power
adjuster.
10. Power adjuster – Secondary air regulator
Using the regulator on the handle, you can reduce
the suction power, e.g. when vacuuming light items
(net curtains, rugs). The wider you open the regula-
tor, the lower the suction power at the nozzle
becomes.
Maintenance and cleaning
Prior to maintenance or cleaning, ensure that the
appliance is switched off and that the mains plug has
been removed from the socket:
Changing the paper filter (fig. 11-13)
The paper filter must be replaced if the window on
the filter replacement indicator is completely red
when the appliance is operating at maximum power
and the nozzle is raised from the floor. The paper fil-
ter should be replaced even if it does not appear to
be full because fine dust can block the pores in the
surface of the filter. The cover can be opened by
pulling the button and folding back until it locks.
Bags full of normal household dust may be disposed
of with household waste.
Insert the new paper filter as far as it will go in the
guide rails; only then can the lid be closed. The
cover cannot be closed unless a paper filter has
been inserted. Please do not use force!
4
Содержание PC 2120
Страница 2: ...1 2 3 4 5 6 7 10 8 9 11 12 13...
