Installing The Glass Shades & Light Bulbs 8.
CAUTION:
Before starting installation,
disconnect the power by turning off the circuit
breaker or removing the fuse at fuse box. Turning
power off using the fan switch is not sufficient to
prevent electric shock.
Step 1.
While holding the switch housing cover
under your fan, locate two single white and blue
wires in the switch housing cover labeled FOR
LIGHT. Make the polarized plug connections:
(Fig. 14)
- White to white
- Blue to black
Step 2.
Carefully push all wires back into the
switch housing, then install the switch housing
cover onto the switch housing with 3 screws
provided. Be sure to tighten all screws. (Fig. 14)
Step 3.
Remove the lock ring from the socket by
turning the lock ring counter-clockwise until it
unlocks. Insert the glass into the glass holder and
turn the lock ring clockwise to tighten the glass.
Repeat for the remaining glass. (Fig. 15)
Step 4.
Install 3x7W LED bulbs (included).
Step 5.
Restore power and your light kit is ready
for operation.
Figure 15
Figure 14
Screws
Switch
housing
cover
Wire connector
Switch housing/
light kit assembly
Glass holder
Bulbs
Glass shade
Lock ring
