R-2323
Polígon Industrial, C/ de la Coma, 2 | 25243 El Palau d’Anglesola | Lleida | España
Tel. 973 32 04 29 | [email protected] | www.progres.es
Sistemes Electrònics Progrés, S.A.
Insert the cables into the hole
and tighten the compression gland
from both ends.
7
Connect the power cable to
the black H6 cable connector on the
relay board or analog input/output
board if you have this option.
8
Connect the data cable to
the series 1 RS-232 port on the
motherboard.
9
In models with more than 32 outputs, the cable connector powering the modem will be connected to one of the relay
extension boards.
NOTE
Close the controller and
re-insert the 6 lateral and 2 central
screws that were removed in step
2.
10
It is important to connect the
antenna cable before powering
up the controller and to leave the
antenna cable extended to avoid
damaging the modem.
The antenna should be installed
at an elevated point so it has the
best coverage possible or close to a
window. Do not leave the antenna
cable gathered; extend it fully.
11
