REHATEAM s.r.l.—vicolo Negrelli
5
—
31040
Castagnole di Paese TV
-
www.rehateamprogeo.com
Service Manual NOIR 2.0 9
Angle adjustment:
Remove the two bolts and nuts
A
that fix the footrest plate to the clamp
B
.
Loosen the two bolts and nuts
C
that fix the clamp
B
to the two tubes.
Turn the clamp until the necessary inclination.
Lay the footrest plate on the clamp to check the
inclination.
Firmly tighten the bolts and nuts
C
.
Finally. Fix the plates with the two bolts and nuts
A
.
Height adjustment:
Remove the two bolts and nuts
A
that fix the footrest plate to the clamp
B
.
Loosen the two bolts and nuts
C
that fix the clamp
B
to the two tubes
until you can easily
turn the clamp and slide the two tubes horizontally through it.
That will allow you to make the distance
X
wider or narrower and thus keep the 2.5° frame
taper. Carry out the adjustment in height as mentioned on the sheet “
footplate distance
”.
Slide the horizontal tube of the footplate through the supports in order to keep the 2.5°
frame taper that will have as a result the fork axle at 90°. Check that.
Check the footplate is centred with respect to the supports.
Adjust the footplate angle and fix the system as above mentioned.
Position adjustment:
4 positions: internal; 2/3 internal; 2/3 external; external
Remove the two bolts and nuts
A
and fix the plate using the other two holes on the same
plate. You can also fix the plate facing front or rear without the need (even though possi-
ble) of reversing the clamp.
If you wish to reverse the clamp, remove the bolts/washer/nuts fixing the footplate tubes
(see “
footplate distance“)
and slide the group “footplate” .
Reverse the assembly, fix the tube at the necessary height and adjust the angle as above
mentioned, keeping in mind to respect the 2.5° taper.
Note: you can remove and insert the footplate-group into the frame tubes without loosen-
ing the grab screw A and the bolts B, thus keeping the distance
X
; the operation, though,
will result a little more difficult because the distance between the two footplate tubes at
their upper side is always wider than the distance of the frame tubes at the insertion point.
To remove the footplate-group, the frame will widen apart as the footplate tubes slide off.
To help the tube come off, you can hit the plate with your hand or gently with a mallet.
On the other hand, to mount it back, you have to insert one footplate tube for approx.1cm,
widen the frame until you can insert the other footplate tube.
That is the point of the maximum pressure, then, as you slide the tubes in, you will notice
that the movement will be easier.
It will be necessary to adjust the inclination.
SERVICE MANUAL
ALUMINIUM FOOTPLATE
.
Keeping the distance
X
, you should notice that,
at the insertion point, the distance between the
footplate tubes is wider than the distance of the
frame tubes.
X
External footplate
A
A
C
C
A A
B
A
C C
A
A
C C
A
X
7 cm
INTERNAL 2/3 INTERNAL 2/3 EXTERNAL EXTERNAL
