ProFurl NDE 42, Руководство по установке

Страница: 9 / 22

CUTTING EXTRUSIONS TO LENGTH
Temporarily fit the gear motor onto the stay, as per steps 1 to
10 of previous page.
Please refer to “L” on drawings.
Please measure “L” :
• Without turnbuckle cylinder: between the upper edge of
rotating shaft…
• With turnbuckle cylinder: between the upper edge of the
turnbuckle cylinder…
• … and the lower edge of the upper terminal, (where the wire
disappears inside the swage terminal).
Every extrusion being 2 meter ( 6’ 6
3/4
”) long, cut one extrusion to obtain a total length as ”G”. The cut
end will be located at the top end of the extrusions.
Caution: the lower (feeder) extrusion (22) should not be cut.
Fitting the extrusions together is described in the Installation Manual pages 18 and 19.
9
L
L
Models
NDE/NDH 42
NDE/NDH 52
The total length “G” of extrusions will be :
G = L + 25 mm ( 1”)
G = L + 50 mm ( 2”)
Headboard 2