Profoto RMI3, Руководство по интеграции

Страница: 12 / 17

RMI3
12
www.profoto.com
Electrical Integration
The minimum connections needed for operation are:
PIN Function Comment
1 GND Digital ground
2 VCC Transmit mode
5 Trig Active high
7 Sync Active high
In order to update the firmware the following pins is needed in addition to the ones
mentioned above:
8 COM TX Transmit to host
9 Reset
15 COM RX Receive from host
16 +3V CPU CPU power supply
Antenna Integration
The Promote RMI3 module is available in one hardware configurations and several
software configurations. RMI3 uses an on board chip antenna. The use of any other
antenna is not approved and will break the modular approval.
All data are to be considered as nominal and Profoto reserves the right to make changes without further notice.