SET-UP
www.profort.com
Pg.
6
If external alarm receivers are used in an PoE network system, be sure to turn the switch on the print to
‘Ethernet’.
Important !!:
Piccolo Light must be restarted after mounting external alarm receivers.
Make sure that the ip-addresses of the units are correct. The ip-address of the PoE interface inside the
Piccolo Light must be the ‘master’ and all the ip-addresses of the external alarm receivers must respond back
to this one.
For setting this correctly follow the instruction described in ‘Piccolo PoE’. The PoE interface inside the
Piccolo Light must setup as the UDS1100 in the document.
Monitoring of detectors and alarm receivers
The system can send a warning if units connected to Piccolo Light are no longer communicating with the
control panel. This applies to both wireless detectors and external alarm receivers. Communication can be
interrupted by weak signals between detector and control panel or cable break between alarm receiver and
control panel. It is also possible to monitor battery status on the wireless detectors.
If you want a warning, detectors and alarm receivers must be created with serial number and text. At the
same time, Piccolo Light must be programmed to send a message when there is no response from detectors
and receivers and in case of low battery warning.
Programming can be done via display by typing the following instructions in 'Programming':
FN (instruction for monitoring)
FB (Low Battery Warning Instructions)
Detectors and receivers that need to be able to send alarm and send error messages must therefore be created
in the list of detectors, as shown in the figure below
.