QUICKGUIDE
www.profort.com
Pg.
4
Activate output in
case of alarm
1234 G1
(G1 = 10 secs., G2 = 20 secs., G3 = 30 secs., G4 =
1 min, G5 = 2 mins, G6 = 4 mins, G7 = 8 mins, G8
= 16 mins og G9 = constant.)
Sets the relay output to activate on alarm on an
input. Output is determined by zone.
Output follows
state on input
1234 GA
Indicates that the output follows the corresponding
input if text is added.
Notice: input signal has higher priority than
command S0 (S + zero) and B0 (B + zero
Deactivate output
in case of alarm
1234 G0
Output is not activated in case of alarm (G+null)
Add macro 0 for
return of
temperature
1234 M0 TEMP <V1 R>
The unit returns value on analogue 1 (e.g.
temperature) when a text message with the word
‘TEXT’ is sent (‘1234’ omitted in macros).
Additional help: see the manual on the CD or on www.profort
Control with call from telephone
Call the unit. Press 1234 (password) when the connection is established, and await two ‘beeps’. Press the
desired code and hang up.
Code examples:
*00 (*01 - *03 for output 1-3)
Pulses output 0 for 10 secs.
*10 (*11 - *13 for output 1-3)
Opens output 0
*20 (*21 - *23 for output 1-3)
Closes output 0
0 (1-9 for macro 1-9)
Performs macro 0
If acknowledgment of an alarm is wanted, it needs to be sent as telephone call or call with DTMF tones. It is
not possible to acknowledge alarms sent as text message.
To acknowledge an alarm: Wait for the beep after the message, then press # on the phone keypad. The unit
hangs up and the alarm is terminated. Thus the message is not sent to the following in the receiver list.
