5
ASSEMBLY
Assembly requires two persons.
Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a nor-
mal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply
wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrenches and your own phillips screwdriver ,
rubber mallet , wire cutters , adjustable wrench , and needlenose
pliers .
To identify small parts during assembly, use the PART IDENTIFICATION CHART in the center of this manual.
2. With the help of a second person, tip the treadmill down
to the position shown.
Attach a Wheel (42) to each side of the Base (38) with a
Wheel Bolt (41) and a Wheel Nut (61) as shown.
Refer to the inset drawing. Clip two U-nuts (10) over the
two round holes in each of the Uprights (14, 15) as
shown.
Identify the Right Upright (15) and the Left Upright (14)
(there is a large hole in the side of the Left Upright).
While a second person holds the Right Upright near the
Wire Harness (53), insert the end of the Wire Harness
into the lower end of the Right Upright and out of the
hole near the upper end as shown. If there are plastic
ties in the lower ends of the Uprights, remove them.
1.
Make sure that the power cord is unplugged.
With the help of a second person, carefully tip the
treadmill onto one side. Partially fold the Frame (84) so
that the treadmill is more stable.
Do not fully fold the
treadmill until it is completely assembled.
Attach four Base Pads (33) to the Base (38) with four 1”
Tek Screws (31).
¥Hazardous Voltage
¥Risk of Electric Shock
¥Unplug Treadmill before Assembly
/Disassembly.
84
38
33
33
33
31
31
1
31
15
14
61
41
42
38
53
2
Hole
10
14, 15
