7
3. Identify the Right Upright (80) and the Right
Upright Spacer (82), which are marked with
stickers.
Insert the Upright Wire (79) through the Right
Upright Spacer (82) as shown. Set the Right
Upright Spacer on the Base (87).
Have a second person hold the Right Upright
(80) near the Base (87).
See the inset drawing.
Tie the wire tie in the Right Upright securely
around the end of the Upright Wire (79). Then,
pull the other end of the wire tie until the Upright
Wire is routed completely through the Right
Upright.
87
Wire Tie
79
80
82
79
3
2.
See the inset drawing.
Cut the plastic tie near
the Upright Wire (79).
Attach a Wheel (88) to the Base (87) with a 3/8"
x 2" Bolt (7) and a 3/8" Nut (11).
Do not over-
tighten the Nut; the Wheel must turn freely.
87
7
11
2
88
Wire
Tie
80
79
1.
Make sure that the power cord is unplugged.
With the help of a second person, carefully tip
the treadmill onto its left side. Partially fold the
Frame (51) so that the treadmill is more stable;
do not fully fold the Frame yet.
Cut the shipping tie securing the Upright Wire
(79) to the Base (87). Locate the plastic tie in
the indicated hole in the Base, and use the tie to
pull the Upright Wire out of the hole.
Attach two Base Feet (84) to the Base (87) in the
locations shown with two Base Foot Spacers
(89) and two #8 x 1" Tek Screws (4).
Then, attach the other two Base Feet (84) with
two #8 x 1" Tek Screws (4).
1
87
4
51
84
84
4
4
4
84
89
84
79
Hole
89
Plastic Tie
Cut
79
