4
ASSEMBLY
Before you begin assembly, carefully read the
following information and instructions:
¥ Place all parts of the AIR WALKER in a cleared
area and remove the packing materials.
IMPORTANT: DO NOT REMOVE THE RUBBER
BANDS FROM THE HUB COVERS (see
assembly step 5).
Do not dispose of any
packing materials until assembly is completed.
¥ Use the drawings below to identify the small
hardware used in assembly.
¥ Read through each assembly step before you
begin.
¥ Make sure that all parts are oriented as shown in
the drawings. Tighten all parts as you assemble
them, unless instructed to do otherwise.
Assembly requires the following tools:
¥ the included allen wrench
¥ your own phillips screwdriver
1.
Before you begin, read the information at the
top of this page.
See figure 1. Find the Left Upright (3).
Note:
There is a ÒTOP LEFTÓ sticker on the upper
end of the Left Upright.
See figure 1. Slide the Left Upright (3) onto the
Base (1). Thread two 3/8Ó x 1Ó Screws (24) into
the Left Upright.
Do not tighten the Screws yet.
See figure 1. Attach the Right Upright (4) in the
same manner.
Fig. 2
Fig. 1
2.
See figure 2. Hold the Top Frame (2) level, and
insert it into the Left and Right Uprights (3 and 4).
Note: It may be helpful to rock the Top Frame
from side to side slightly as you insert it.
Make sure that the indicated rubber bands are
not pinched between the Top Frame and the
Uprights. Attach the Top Frame with four 3/8Ó x 1Ó
Screws (24).
See figures 1 and 2. Tighten the eight 3/8Ó x 1Ó
Screws (24).
3
ÒTOP LEFTÓ
Sticker
ÒTOP RIGHTÓ
Sticker
3
1
24
24
24
4
4
2
Rubber
Band
Rubber
Band
2 1/4" Lower Screw (26)Ð2
2" Upper Screw (25)Ð2
#8 x 1/2" Screw (31)Ð8
3/8" x 1" Screw (24)Ð8
3/8" Curved Washer (27)Ð4
24
