6. Power on the LCD display by pressing the “On/Off” button. Wait until the weight
readings all show zero or press the “Tare” button to zero. Press “Function” to toggle
between lbs and kgs.
7.
The battery power indicator represents the amount of battery life available in 3
levels. If the display shows only the battery outline, replace the AA batteries
accordingly.
8. Using jacks carefully lower each wheel onto the center of the weighing pads, or
carefully drive the vehicle up onto the center of the weighing pads. The more
centered each wheel is on the pad, the more accurate the reading will be.
9. Never press “Tare” if the vehicle is on the pads, otherwise the vehicle has to be
removed and the scale must be zeroed again.
10. While the car is on the pads. Shake each of the corners of the car up and down
to relieve any residual stress or friction within the chassis.
11. The car total weight, individual weight of each wheel as well as its percentage to
the total weight will be shown on the default screen. (
Screen #1
)
Toggling between screens:
12. Press and hold the “Function” button with one finger, press the “Tare” button
once. The display passes to
Screen #2
, which displays the total Front and Rear
weight percentages.
13. Press and hold the “Function” button with one finger, press the “Tare” button
again, and the display will pass to
Screen #3
, which displays the total Left and
Right weight in percentages.
14. Press and hold the “Function” button with one finger, press the “Tare” button
again, and the display passes to
Screen #4
, which displays the Cross weight of
(LF) Left Front, and (RR) Rear Right percentage.
15. Press and hold the “Function” button with one finger, press the “Tare” button
again, and the display passes to
Screen #5
, which displays the Cross weight of
(RF) Right Front, and (LR) Left Rear percentage.
16. It is possible to scroll through the screens, but pressing and holding “Function”,
while repeatedly pressing the “Tare” button.
17. Press ON/OFF to power off the unit.
18. Switch off all the weighing pads, and make sure the LED lights are all off.
