ProForm 400 H Elliptical, Руководство пользователя, Страница: 10 / 24

10
10
9. The Console (10) requires four “D” batteries
(not included); alkaline batteries are recom-
mended. Remove the battery cover from the
back of the Console and insert four batteries
into the battery compartment.
Make sure that
the batteries are oriented as shown by the
diagram inside the battery compartment.
Then, reattach the battery cover.
Have a second person hold the Console (10)
near the Upright (2) as shown. Connect the
console wire to the Upper Wire Harness (18).
Attach the Console (10) to the Upright (2) with
four M4 x 16mm Screws (60).
Be careful to
avoid pinching the wires.
Note: The Console (10) can be operated with
an optional power supply instead of batteries.
To purchase a power supply, call the toll-
free telephone number on the front cover
of this manual.
Plug one end of the power
supply into the jack on the elliptical exerciser.
Plug the other end of the power supply into
an appropriate outlet that is properly installed
in accordance with all local codes and ordi-
nances.
10. Identify the Left Upper Body Arm (4), which is
marked with a “Left” sticker. Orient the Left
Upper Body Arm so that the indicated tube is
facing inward.
Lubricate the upper end of the left Upper Body
Leg (6) using a small amount of the included
high-temperature lubricant. Then, slide the
Left Upper Body Arm (4) onto the Upper Body
Leg.
Apply a generous amount of grease to the
Pivot Axle (16). Also, apply a small amount of
grease to a Wave Washer (27). Then, insert
the Pivot Axle through the Left Upper Body
Arm (4), an Upper Body Arm Spacer (29), the
Wave Washer, and the Upright (2).
Make sure
that the Upper Body Arm Spacer is orient-
ed as shown, with the arrow pointed down-
ward.
2
Console Wire
18
60
2
4
6
29
27
16
Tube
Grease
Grease
Arrow
Lubricate
10
Batteries
Battery
Cover
10
Avoid pinching the
wires during this step
9