2
CAP15/10 REV.A
www.PROFLO.com
Fig. 1 Faucet Installation
1. From beneath the sink, insert the faucet
manifold and control assemblies through the
3 holes in the sink deck.
2. Following the sequece of assembly outlined
ensure the o-ring (No. 24) is properly seated in
the o-ring race of the canopy (No. 25). Thread
the canopy (No. 25) onto the cold (right hand)
side control unit (No. 16) and hand-tighten only.
Repeat the steps for the hot (left hand) side
control unit.
3. Following the sequence of assembly outlined
ensure the washer (No. 24) is property seated in
the washer race of the canopy (No. 7) onto the
spout tower. Hand-tighten only.
4. Adjust the lower lock nut and upper canopies
to achieve the desired installation height of the
assembled unit. Hint- Placing a handle on the
stem at this point will help achieve optimum
visual appeal. Ensure the handle hub
completely covers the canopy.
5. Securely tighten all connections. On an
uneven surface, use silicone sealant to seal
the faucet to the deck.
6. Following the sequence of assembly outline
insert the spout assembly (No. 8-12) into the
receiver of the spout canopy (No. 7 )
7. Thread the spout nut (No. 11) onto the spout
canopy (No. 7) and tighten using an apppropriate
sized wrench. Hint- to prevent damage to the
finish, slip a piece of heavy cloth between the
wrench faces.
8. Following the sequence of assembly outlined.
Install the handles (No. 27) on the cartridge
(No. 16) place the appropriate indexer onto the
handle and install screw (No. 30). Tighten
securely. Repeat for each side. Hint- Hot
(left hand) side indexer is red and cold
(right hand) side indexer is blue.
9. Connect the hot and cold water supply
connector to the appropriate inlet. If you are
using coned supply risers, use the brass coupling
nuts (No. 32) supplied with the faucet kit. For
installations employing other types of supply
connectors, consult the manufacturer’s installations
instructions.
10. Turn the water on and check for leaks. To
correct for leaks at a supply connection, gently
tighten the faucet on and check for adequate
flow rate. If flow rate is low, remove aerator, flush
and reassemble.
HOT IN
COLD IN
25
27
22/23
30
28/29
33
1
16
12
11
7
1/2”-14NPSM
PFXU3085
PFXU3085