PROFILO BM6224 - annexe 2, Руководство по эксплуатации

Страница: 16 / 28

en
16
Timer programming *
* depending on model
You can delay the start of the programme
in 1-hour steps up to 24 hours.
–
Close the door.
– Switch on ON/OFF switch
(
.
– Press button
P
until the digital
display
H
jumps to
œ
:
‹‚
.
– Press button
P
until the displayed
time corresponds with your
requirements.
– Press START button
@
, timer
programming is activated.
– To delete the preselected starting time,
press the button
P
until
œ
is
indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.
End of programme
The programme has ended when the
value
‹
:
‹‹
is indicated on the numerical
display
H
.
Switching off the appliance
Short time after the end of the programme:
–
Switch off ON/OFF switch
(
.
– Turn off the tap (not applicable if Aqua-
Stop fitted).
– Remove the utensils when they have
cooled down.
ã=
Warning
At the end of the programme please open
the door fully and not partially when
emptying the dishwasher. Any escaping
water vapour could damage sensitive
worktops.
Interrupting the programme
– Switch off ON/OFF switch
(
.
The LEDs go out. The programme is
saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave the
door ajar for several minutes and then
close. Otherwise, expansion (pressure)
may cause the appliance door to
spring open or water to run out of the
appliance.
– To continue the programme, switch on
the ON/OFF switch
(
again.
Terminating the programme
(Reset)
– Press START button
@
for
approx. 3 sec.
The numerical display
H
indicates
‹
:
‹‚
.
– The programme sequence lasts
approx. 1 min. On the digital
display
H
is indicated
‹
:
‹‹
.
– Switch off ON/OFF switch
(
.
Changing the programme
When the START button
@
has been
pressed, the programme cannot be
changed.
The only way a programme can be
changed is by Cancel programme (Reset).