Note:
The charger cable needs to be removed from the tool to check the
charge state.
Note:
Once connected for charging, the battery status indicator lights will illuminate
red and remain so whilst charging. The green LED will illuminate when the tool
is fully charged
.
Charging with using an AC Adaptor
1.
Plug one end of the USB cable into the AC Adaptor (not included) and connect the
adaptor into mains power outlet.
2.
Plug the other end of the USB cable directly into
the charging input of the device.
Charging Using A USB Outlet
1.
1. Plug the USB cable directly into the charging input.
2. Charge via USB cable to a USB outlet.
2. INSTALLING ACCESSORIES
Attaching the LED Light Collar
The LED collar can be attached to provide additional direct
lighting on your workpiece during detailed, precision work.
1.
Turn the shaft collar anticlockwise to loosen and remove
it.
2.
Slide the LED collar onto the shaft and turn it clockwise
to tighten it into place.
3.
Flip the lever on the back of the LED collar to the ‘I’
position to turn it on.
4.
To turn off the LED collar, flip the lever to the ‘0’
position.
Attaching Accessories
1.
Press and hold the spindle lock button.
2.
Using the supplied wrench, slightly loosen the collet
nut.
3.
Insert the shaft of the accessory into the collet.
4.
With the spindle lock button engaged, finger tighten the
collet nut until the accessory shank is firmly gripped by
the collet.
WARNING!
ENSURE THAT THE TOOL IS SWITCHED
OFF BEFORE PERFORMING ANY OF THE FOLLOWING
OPERATIONS
.
