Profi-Partner 45126, Инструкция по эксплуатации

Страница: 15 / 16

15
DC voltage converter
• Before connecting, make sure that the voltage transformer is switched off.
• Before connecting the consumer, make sure that it is switched off and that its
Power consumption does not exceed 200 watts.
• Connect the consumer to the Power Pack.
• Switch on the voltage converter. If the voltage converter functions correctly, the green LED lights up.
LED on. If the green LED does not light up, switch off the consumer and then immediately switch the
Switch off the voltage transformer. (See Troubleshooting) It is possible that the voltage transformer
overloaded or the input voltage is too low.
USB output jack

Thanks to its USB connection, the power station can be used as a charger for mobile phones,
smartphones, tablet computers, MP3 players and similar devices. To charge a USB device, first connect
it to the charger cable (not included). Plug the USB connector of the charging cable into the USB port
of the power cradle. Start the charging process by setting the switch (10) to position "I
Attention:
Some rechargeable loads have a separate charging unit which can be connected to the
can be charged with AC voltage. However, some devices are equipped with integrated
The load unit has been manufactured (please refer to the respective operating instructions).
This type of equipment can damage the voltage transformer and should not be used with this charger.
can be operated.
The temperature of the connected consumer should be checked for approx. 15 minutes. If it
too hot, it may be an indication that this device is not connected to the voltage transformer.
can be operated.
Problems and solutions
Problem Bottom Resolution
Insufficient
output
Voltage below 12 Volt
Power consumption too high
of the operated device
Voltage transformer is not
completely warmed up
Securing the
voltage transformer is
blown
Load Power Pack immediately
Reduce power consumption to a maximum of 200
watts
The load and voltage transformer
switch off and remove the consumer. The
Now switch on the voltage transformer again and
Run for at least 2 minutes. Then again
and quickly switch off the switched off
Connect the consumer. Now connect both devices
again. switch on. A new 25 ampere. Insert fuse. To
Replacement: use a needle-nose pliers.
LED does not light
up
Inadequate energy or
more immoderate
voltage drop
voltage transformer is
overloaded
Check voltage and if there is a drop below 12
Volt, reload.
Reduce power consumption to a maximum of 200
watts.
Consumer does
not start
High
performance fluctuations
at startup
The device can be quickly inserted and removed 5
times in a row.
to switch off the power supply to generate the
necessary energy.
generate. If the device does not work now
or doesn't start, it can't start with the Power
Pack can be operated.
television
interference
Image interference (snow) The voltage transformer as far as possible from the TV,
Remove the antenna and the coaxial cable.
Place
Check connections