Profi Cook PC-WKS 1108, Инструкция по эксплуатации

Страница: 39 / 68

39
CAUTION: Overload!
• If you use extension cords, they should have a
conductor cross-section of at least 1.5 mm
2
.
• Do not use multiple sockets, as this appliance is
too powerful.
Power ON / OFF
Power ON: Press the ON / OFF button (9). The
pilot lamp in the button lights blue.
The preset button (10) for temperature
selection flashes blue.
Power OFF: Press the ON / OFF button (9)
again. The pilot lamps in the buttons
go out.
Operation
NOTE:
Always use fresh, cold water.
Heating:
1. Set the appliance onto a flat surface.
2. Open the water kettle by pressing the button (4) on
the handle.
3. Fill in clear water (max 1.5 liters). You can check
the filling level on the level gauge (6) of the applian-
ce.
4. Close the lid (3).
5. Place the kettle flush onto the base unit (7).
6. Connect the appliance only to a correctly installed
safety socket. When the power plug is inserted into
a power outlet, two beeps can be heard.
7. Press a button for temperature selection (10) (70
°C, 80 °C, 90 °C, or 100 °C).
8. Use the ON / OFF button (9) to turn on the
appliance. The selected button for temperature
selection (10) flashes blue.
9. The appliance heats up, the pilot lamp in the
ON / OFF button (9) goes out when the selected
temperature has been reached, and two beeps can
be heard. The respective button for temperature
selection (10) lights blue for ca. 1 minute and then
goas out with a beep.
Heating und Keeping warm:
1. Perform the steps 1 to 7 as described under “Hea-
ting”.
2. Press the button (11) and then the ON / OFF
button (9) to start the keep-warm process at the
preset temperature. The button for temperature
selection (10) flashes.
3. When the set temperature has been reached, two
beeps can be heard and the buttons (11),
ON / OFF, and temperature selection (10) light
steadily.
4. The keep-warm function remains active for one
hour, and the button for temperature selection (10)
flashes during this time. Then the entire process
can be repeated for another hour.
Quick Start
1. Use the ON / OFF button (9) to turn on the
appliance. The pilot lamp in the button lights blue.
2. When the temperature has been reached, two
beeps can be heard and the pilot lamp in the ON /
OFF button (9) goes out.
Pausing / Terminating Operation
There are two ways to interrupt the boiling process or
to terminate it:
• The appliance will shut off automatically after the bo-
iling process. The respective pilot lamps go out.
• Press the ON / OFF button (9) to end the boiling
process.
NOTE:
A beep can be heard when you remove the water
kettle from the base unit (7).
CAUTION:
Never remove the appliance from the base unit (7)
without turning it off in advance.
The contacts on the base unit (7) are not suitable for
interrupting the current.
WARNING: Danger of burns!
• Keep the lid (3) closed while pouring.
• During operation, the housing becomes hot. Do
not touch it and let the appliance cool down before
storing it.
• Disconnect the power plug (8).
• Empty the water tank.
Power Cable Take-up Device
The power cable (8) can be wound onto the bottom of
the base unit (7).