39
Electric Connection
• Before inserting the power plug into the out-
let, check that the mains voltage to be used
matches that of the device. You can find the
required information on the nameplate.
• Connect the device only to a correctly installed
safety socket.
Operation
Switch settings
ON = Operation
O = Off
R = Reverse operation to eliminate jams
Notes on application
• For best results, use fresh and ripe fruits only.
• Cut the foods into small pieces in order to
avoid clogging.
• If the device jams during operation, press and
hold the switch (8) at “R” position for approx. 3-5
seconds. If necessary, repeat 2 or 3 times.
• For better efficiency, do not feed the fruits in
too fast.
• When squeezing leaf vegetables or wheat
-
grass, we recommend adding some water at
the same time.
• Before juicing, remove inedible skin or pith,
such as that of oranges. Also remove the skin
of citrus fruits.
• When juicing foods containing hard seeds or
stones, these must be removed beforehand.
• When juicing bananas, we recommend to first
squeeze some juicy foods or to add some
water. The liquid will support the juicing of the
bananas.
• When juicing foods of different hardness,
always start with the softest food.
Juice extraction
NOTE:
• The device has a safety switch. The motor
will not turn on if the feeder tray (2) is not
fitted correctly.
NOTE:
• Do not operate the device for more than
10 minutes at a time.
1. Clean the fruits or vegetables. Remove hard
skin and seeds if present. Then cut the food
into small pieces.
2. Set the switch to “ON” position. The motor
starts.
3. Place the fruit into the filler opening and push
with the tamper.
4. The juice now flows into the juice container.
The pulp is collected in the pomace container.
NOTE:
• The juice container has a capacity of 1 liter.
Stop the operation in time.
• Empty the pomace container periodically. In
order not to impair the performance of the
device, do not let it become too full.
Cleaning
WARNING:
• Before cleaning, switch the device off and
pull the power plug.
• Under no circumstances should you immerse
the device in water for cleaning purposes.
Otherwise this might result in an electric
shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive
items.
• Do not use any acidic or abrasive detergents.
For cleaning the outside of the machine use only a
damp washing-up cloth. Dry the device afterwards
with a cloth.
Tamper, feeder tray, sieve, rotary scraper,
container, juice / pulp container
• Clean these components in a rinsing bath.
• There is a rubber plug at the bottom of the con
-
tainer (6) sealing the pulp outlet to the motor
housing. You may remove this plug to better
clean the pulp outlet.
