Profi Care 330850, Инструкция по эксплуатации

Страница: 48 / 86

PC-BS3085A_IM 08.07.20
48
• During operation, the LEDs on the floor nozzle light up
for better visibility in dark areas.
CAUTION:
You cannot replace the LEDs.
• Stick the lower end of the suction pipe onto the connec-
tor on the floor nozzle. Note the contact pins on the floor
nozzle. The suction pipe must audibly s snap into place.
• To disconnect the suction pipe, press the release (13)
and pull out the pipe at the same time.
Flexible Suction Hose
Thanks to this expandable suction hose, you will be able to
reach any hard-to-reach area.
• Insert the end of the suction hose, where the release is
located, into the connection on the handset. Note the
recess for the release on the handset. The connection
must audibly engage.
• In order to disconnect the suction hose, press the re-
lease on the suction hose and pull it off simultaneously.
Nozzle Attachments
There are three different ways to connect these nozzles to
the appliance:
Connection at the Hand Unit
• Plug one of the nozzles into the port on the handset.
Note the recess for the release on the handset. The
connection must audibly engage.
• In order to release the respective nozzle, press the
release (10 or 11) while simultaneously pulling it off.
Connection to the Suction Pipe
At the lower end of the suction pipe, you will find the same
plug connection as on the handset. Mount / dismount the
nozzle as described above.
Connection to the Flexible Suction Hose
• Note the recess with the guide lug on the connection of
the suction hose.
• Take one nozzle and plug it onto the suction hose. The
connection must audibly engage.
• In order to release the respective nozzle, press the
release (10 or 11) while simultaneously pulling it off.
Crevice Nozzle
For vacuuming dirt from corners, joints and small gaps.
Combined Upholstery / Brush Nozzle
This nozzle is suitable for removing dust from smaller
surfaces such as upholstery, furniture or curtains. Use
the nozzle with locked brush to prevent scratching of the
surface to be cleaned.
• For this, press the button and push the brush to the end
of the nozzle. It must engage.
• Press the button again to unlock the brush.
Assembly the Wall Holder
WARNING:
Make sure beforehand whether there are cables in the
wall which could be damaged!
CAUTION:
Place the wall holder so that the appliance is not exposed
to direct sunlight or other heat sources.
NOTE:
If you would like to simultaneously use the wall mount as
a charging station, there must be a power outlet nearby.
1. Measure the height for the wall holder. Hold the vacuum
cleaner against the wall with the suction pipe and the
floor nozzle installed.
2. Measure the distance between the two oblong holes of
the bracket and drill two holes in the wall while maintain-
ing this distance.
3. Insert the dowels into the wall.
4. Use a screwdriver to screw the screws into the dowels
and make sure they protrude around 3 - 4 mm.
5. Use the screws to hang the bracket against the wall.
Charging the Rechargeable Battery
CAUTION:
Do not charge the rechargeable battery unsupervised.
1. Turn off the appliance.
2. Connect the power supply plug to one of the sockets
listed below.
- A connection socket (3) is located directly on the
appliance.
- If you have already mounted the wall bracket, use the
connection socket on the bottom of the wall bracket.
Hang the appliance in the wall bracket. Always attach
it to the top of the latch first. The connection must
audibly engage.
3. Connect the power adapter to a certified wall socket.
Charge the appliance for approx. 4,5 hours before first-
time use.
NOTE:
• The indicator lights show the state of charge of the
rechargeable battery. (25 %, 50 %, 75 %, 100 %)
• The appliance has electronic charge control, which
prevents overcharging.
• Charging is completed when all 4 indicator lights
are lit.
• Once the appliance is disconnected from the power
adapter, the indicator lights go out.
• It is normal for the appliance to heat up during
charging.
4. Disconnect the power adapter from the outlet once the
rechargeable battery has been charged completely.