E-18
Installing the AC Power Cord Clamp
• Be sure to connect the power cord only after confirming that the
PS-A unit rear face power switch is turned OFF.
Attaching the AC Power Cord
1) Open the AC Power Cord Clamp and insert the AC Power Cord as shown in fig. 1. Then,
close the Cord Clamp until it clicks into place and locks around the AC Power Cord Collar.
• The Cord Clamp has four teeth for locking. These are to adjust the amount of
grip used to hold the AC Power Cord Collar.
6
Wiring
• To avoid an electric shock, check that the PS-A's power supply is
turned OFF, via a breaker, or similar unit before connecting the
PS-A's power cord to the AC connector.
• To avoid the dangers of fire, electric hazards and equipment dam-
age, be sure to use only the specified voltage when operating the
PS-A.
WARNINGS
*1
L : AC Input Terminal-live line
N : AC Input Terminal-neutral line
FG : Ground Terminal connected to the PS-A chassis
Insert the power cord (AC inlet plug) into the PS-A's bottom face AC connector.
N
L
FG
AC Connector
*1
Figure 1
AC Plug Collar
AC Plug
Cord Clamp
• The Power Cord included in the PS-A unit’s package is designed only for
AC100V or AC115V use. Any other voltage will require a different cord.
